C&K systems System 238 Manual de Instalação descarregar pdf (Página 18)

SYSTEM 238 Installation Manual

Command Location 2E: Audible/Visual Switches

Digit Position (1): Entry Pre-alarm Enable

0 = No

1 = Yes: sounds keypad buzzers during entry delay

Digit Position (2): Exit Pre-alarm Enable

0 = No

1 = Yes: sounds keypad buzzers during exit delay

Digit Position (3): Bell Reverse Operation

0 = No

1 = Yes: supplies bell voltage in non-alarm state; Bell requires external power supply

Digit Position (4): Ring Back

Digit Position (5): Disable Loop LEDs

0 = No

1 = Yes: turns off keypad zone LEDs after 5 minutes

Default Values

(1) (2) (3) (4) (5)

10 001

Command Location 2F: Unit Control

Digit Position (1): Local System Only

Default Values

(1) (2) (3) (4)

00 11

Digit Position (2): Enable Daily Dynamic Battery Test

Digit Position (3): Enable Four Minute Power-Up Delay

Digit Position (4): Enable Soft Zone Operation

0 = No

1 = Yes: allows use of Emergency, Fire, and Police keys

0 = No

1 = Yes: disables all communications except RPS

0 = No

1 = Yes: tests battery under load every 24 hours

0 = No

1 = Yes: suppress alarms on power-up for 4 minutes



0 = No

1 = Yes: Automatic Bell test after arming (and Exit Delay has expired) for local or non-supervised

accounts; follows closing report for supervised accounts; sounds bell for 2 seconds.

Command Locations 2E and 2F

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sem comentários

C&K systems System 238 Manual de Instalação Página 18